Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Center Floor)

ELECTRICAL KEY OSCILLATOR (for Center Floor) > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY


  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.




      B279202E01
    1. Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
      Standard Measurement 
      a
      100 mm (3.94 in.) or less

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.



2. REMOVE REAR SEAT CUSHION LOCK HOOK


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the RH side and the LH side.



3. REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    B279164
  1. Disconnect the connector.

  1. Disengage the clamp and remove the No. 2 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.