Home › Drivetrain · U660E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT PADDLE SWITCH

SHIFT PADDLE SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)


    C207558E04
  1. Measure the resistance between each terminal when the shift paddle switch is moved to each position.
    Text in Illustration 
    *a
    Component without harness connected
    (transmission shift switch LH)
    *b
    Component without harness connected
    (transmission shift switch RH)

    Standard Resistance:
    Transmission Shift Switch LH: 
    Tester Connection
    Switch Condition
    Specified Condition
    3 (ECC) - 2 (SFTD)
    Pull "-" continuously
    (Down-shift)
    Below 1 Ω
    Release
    10 kΩ or higher
    4 (ECC1) - 2 (SFTD)
    Pull "-" continuously
    (Down-shift)
    Below 1 Ω
    Release
    10 kΩ or higher
    Transmission Shift Switch RH: 
    Tester Connection
    Switch Condition
    Specified Condition
    3 (SFTU) - 2 (ECC1)
    Pull "+" continuously
    (Up-shift)
    Below 1 Ω
    Release
    10 kΩ or higher

    If the resistance values are not as specified, replace the shift paddle switch (transmission shift switch assembly).