Home › Drivetrain ยท U660E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT PADDLE SWITCH

SHIFT PADDLE SWITCH > REMOVAL

for Preparation Click here


NOTICE:
  1. Do not replace the spiral cable with the battery connected and the engine switch on.
  2. Do not rotate the spiral cable without the steering wheel with the battery connected and the engine switch on.
  3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
  4. Do not remove the steering sensor from the spiral cable.



1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


2. REMOVE HORN BUTTON ASSEMBLY
(Click here)


3. REMOVE STEERING WHEEL ASSEMBLY


    C239680E01
  1. Remove the steering wheel assembly set nut.
    Text in Illustration 
    *a
    Matchmark

  1. Put matchmarks on the steering wheel assembly and steering main shaft.

  1. Disconnect the connectors from the spiral cable sub-assembly and steering wheel assembly.



    C239681E01
  1. Using SST, remove the steering wheel assembly.
    Text in Illustration 
    *a
    Turn
    *b
    Hold

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05070)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



4. REMOVE STEERING PAD SWITCH ASSEMBLY
  1. Disconnect the steering pad switch connector from the spiral cable sub-assembly.



    C239682E01
  1. Disconnect the No. 1 switch wire connector.
    Text in Illustration 
    *1
    Pin
    *2
    Guide
    *3
    Clamp

  1. Disengage the clamp.

  1. Remove the 2 screws.

  1. Disengage the 2 claws, 2 pins and 2 guides to remove the steering pad switch assembly.



5. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)


C238883
  1. Remove the 2 screws.

  1. Disengage the 4 pins and remove the 2 shift paddle switches (transmission shift switch assembly).



6. REMOVE NO. 1 SWITCH WIRE


    C238884
  1. Disengage the 5 guides to remove the shift paddle switch with No. 1 switch wire from the steering wheel assembly.



    C224989E01
  1. Remove the 2 clamps.
    Text in Illustration 
    *1
    Clamp

  1. Disconnect the 2 connectors to remove the 2 shift paddle switches (transmission shift switch assembly) from the No. 1 switch wire.