Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR COMBINATION LIGHT PACKING


    E225015
  1. Remove the rear combination light packing.

    NOTICE:
    1. Be sure to remove all the traces of the old packing from the body.
    2. Do not reuse the removed packing. Be sure to install a new rear combination light packing to prevent water ingress.



2. REMOVE REAR SIDE MARKER LIGHT BULB


    E225016
  1. Turn the rear side marker light socket with the rear side marker light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the rear side marker light bulb from the rear side marker light socket.



3. REMOVE REAR TURN SIGNAL LIGHT BULB


    E225018
  1. Turn the rear turn signal light socket with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the rear turn signal light bulb from the rear turn signal light socket.



4. REMOVE TAIL AND STOP LIGHT BULB


    E225020
  1. Turn the tail and stop light socket with the tail and stop light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.

  1. Remove the tail and stop light bulb from the tail and stop light socket.



5. REMOVE REAR BUMPER UPPER SIDE RETAINER


    E226669
  1. Using a screwdriver, disengage the claw and remove the rear bumper upper side retainer as shown in the illustration.