AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > DIAGNOSIS SYSTEM |
| DESCRIPTION |
Air conditioning system data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform troubleshooting.
| CHECK DLC3 |
Check the DLC3 (Click here).
| LIST OF OPERATION METHODS |
By operating each of the air conditioning control switches as shown in the diagram below, it is possible to enter diagnostic check mode.

| INDICATOR CHECK |
Turn the ignition switch off.
Turn the ignition switch to ACC and wait at least 5 seconds.
![]() |
Turn the ignition switch to ON while pressing the air conditioning control assembly "AUTO" switch and "Recirculation/Fresh" switch simultaneously. Hold both switches until the indicator check screen appears.
![]() |
The indicator check is automatically performed when panel diagnosis is activated. Check that the indicators light up and go off 4 times at 1 second intervals continuously.
| *a | Indicator Blinking Pattern |
| *b | ON |
| *c | OFF |
| *d | 1 sec. |
| SENSOR CHECK (DTC CHECK) |
Start the engine and warm it up.
Perform the indicator check.
![]() |
Read the DTC displayed on the accessory meter display.
| *a | Diagnostic Trouble Code (DTC) |
![]() |
If the DTCs are difficult to read because they change automatically, turn the "Driver TEMP" switch clockwise to display the DTCs one at a time so that they can be read easily. The DTCs change step by step each time the "Driver TEMP" switch is turned clockwise.
Clear DTCs
![]() |
During the sensor check, press the "FRONT DEF" switch and "REAR DEF" switch simultaneously.