Home › Power Source / Network ยท 2GR-FE BATTERY / CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR REAR END COVER


    A128071
  1. Remove the 3 nuts and generator rear end cover.



2. REMOVE GENERATOR TERMINAL INSULATOR


    A128072
  1. Remove the generator terminal insulator from the generator coil.



3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A128073
  1. Remove the 2 screws and brush holder from the generator coil.



4. REMOVE GENERATOR COIL ASSEMBLY


    A128074
  1. Remove the 4 bolts.



    A118275E09
  1. Using SST, remove the generator coil assembly.
    Text in Illustration 
    *a
    Turn
    *b
    Hold

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)



    A118365E01
  1. Remove the generator washer.



5. REMOVE GENERATOR PULLEY WITH CLUTCH


    A240513
  1. Using a screwdriver, remove the generator pulley cap.

    NOTICE:
    Do not reuse the generator pulley cap.

  1. Mount the generator drive end frame in a vise tightly.



    A128069E04
  1. Confirm SST (A) and (B) shown in the illustration.
    Text in Illustration 
    *1
    SST (A)
    *2
    SST (B)

    SST
    09820-63021  



    A185232E03
  1. Place the rotor shaft end into SST (A).
    Text in Illustration 
    *1
    Rotor Shaft
    *2
    SST (A)



    A185233E02
  1. Fit SST (B) to the generator pulley with clutch.
    Text in Illustration 
    *1
    Generator Pulley with Clutch
    *2
    SST (B)
    *3
    SST (A)



    A194274E02
  1. Loosen the pulley by turning SST (B) in the direction shown in the illustration.
    Text in Illustration 
    *1
    SST (B)
    *2
    SST (A)

    NOTICE:
    1. Check that the drive end frame is secured in the vise tightly.
    2. Hold SST (A) tightly during the operation.

  1. Remove SST from the generator assembly.

  1. Remove the generator pulley with clutch from the rotor shaft.



6. REMOVE GENERATOR ROTOR ASSEMBLY


    A205249E01
  1. Remove the generator rotor assembly.



7. INSPECT GENERATOR DRIVE END FRAME BEARING


    A128080
  1. Check that the bearing is not rough or worn.

    OK:
    The bearing rotates smoothly.

    If the bearing does not rotate smoothly, replace the bearing.



8. REMOVE GENERATOR DRIVE END FRAME BEARING


    A128076
  1. Remove the 4 screws and bearing retainer from the drive end frame.



    A128077E01
  1. Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)