Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    E226228
  1. Remove the nut and front wiper arm and blade assembly LH.



2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    E226229
  1. Remove the nut and front wiper arm and blade assembly RH.



3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


    E226230
  1. Disengage the 2 clips and 3 guides, and remove the front fender to cowl side seal LH as shown in the illustration.



4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

HINT:
Use the same procedure as for the LH side.



5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


  1. Disengage the 6 claws and guide as shown in the illustration.


    E226232



  1. Disengage the 8 guides and pull out the cowl top ventilator louver sub-assembly as shown in the illustration.


    E226234



6. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
  1. Operate the wiper and stop the windshield wiper motor at the automatic stop position.



    E226236E01
  1. Disconnect the connector.
    Text in Illustration 
    *1
    Motor Grommet

  1. Remove the 2 bolts.

  1. Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.

    NOTICE:
    Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.



7. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    E226238E01
  1. Using a screwdriver, separate the No. 1 rod from the windshield wiper motor assembly as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape
    *2
    No. 1 Rod

    HINT:
    Tape the screwdriver tip before use.



    E226240
  1. Using a T30 "TORX" socket wrench, remove the 2 bolts and windshield wiper motor assembly from the wiper link assembly.