Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH

WASHER LEVEL WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL LEVEL WARNING SWITCH ASSEMBLY


    E226463
  1. Install the level warning switch assembly.

  1. Connect the connector.



    E227001
  1. Connect the washer hose.



2. ADD WASHER FLUID
  1. Add washer fluid to the washer jar.



3. INSTALL FRONT FENDER LINER RH
  1. Install the front fender liner RH with the 4 clips and 5 screws.

  1. Install 2 new grommets.



    E226454E01
  1. Install the pin hold clip as shown in the illustration.
    Text in Illustration 
    *1
    Clip
    *2
    Pin Hold Clip
    *a
    Correct
    *b
    Incorrect

    NOTICE:
    Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

  1. Install the clip.



4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
  1. Install the front wheel opening extension pad RH with the 3 screws



5. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1049 kgf*cm , 76 ft.*lbf }