Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL SWITCH

DOOR CONTROL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


    B279066E08
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (L) - 1 (E)
    Lock switch pushed
    Below 1 Ω
    2 (L) - 1 (E)
    off
    10 kΩ or higher
    9 (UL) - 1 (E)
    Unlock switch pushed
    Below 1 Ω
    9 (UL) - 1 (E)
    off
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Power Window Regulator Master Switch Assembly)
    If the result is not as specified, replace the power window regulator master switch assembly.



2. INSPECT DOOR CONTROL SWITCH ASSEMBLY


    B274464E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    4 (L) - 3 (E)
    Locked
    Below 1 Ω
    4 (L) - 3 (E)
    off
    10 kΩ or higher
    2 (UL) - 3 (E)
    Unlocked
    Below 1 Ω
    2 (UL) - 3 (E)
    off
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Door Control Switch Assembly)
    *b
    Unlock
    *c
    Lock
    If the result is not as specified, replace the door control switch assembly.