Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front Side)

ULTRASONIC SENSOR (for Front Side) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER


    E232468E01
  1. Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the front bumper assembly.
    Text in Illustration 
    *A
    LH Side
    *B
    RH Side
    *a
    Keyhole
    *b
    Snap

    NOTICE:
    1. Do not damage the front bumper with the protrusion when installing the retainer.
    2. Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.

    HINT:
    When installing the retainer, align the keyhole and snap as shown in the illustration.



2. INSTALL NO. 1 ULTRASONIC SENSOR


    E228019E01
  1. Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.
    Text in Illustration 
    *A
    LH Side
    *B
    RH Side

    NOTICE:
    Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.



3. INSTALL FRONT BUMPER ASSEMBLY
(Click here)