Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH

ENGINE HOOD COURTESY SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)


    B277171
  1. Apply MP grease to the sliding areas of the lock.

  1. Connect the hood lock control cable assembly.

  1. Install the hood lock assembly with the 3 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. w/ Engine Hood Courtesy Switch:

    1. Connect the connector.



2. INSTALL RADIATOR GRILLE SUB-ASSEMBLY
(Click here)


3. INSPECT HOOD SUB-ASSEMBLY


  1. Check that the clearance measurements of areas a through d are within each standard range.


    B277176E01


    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    a
    2.45 to 6.45 mm (0.0965 to 0.254 in.)
    b
    3.55 to 7.55 mm (0.140 to 0.297 in.)
    c
    2.0 to 5.0 mm (0.0787 to 0.197 in.)
    d
    -1.5 to 1.5 mm (-0.0591 to 0.0591 in.)



4. ADJUST HOOD SUB-ASSEMBLY
(Click here)