PURGE VALVE > REMOVAL |
| 1. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.
| 2. REMOVE PURGE VSV |
![]() |
Disconnect the connector and wire harness clamp.
Disconnect the 2 fuel vapor feed hoses.
![]() |
Remove the bolt and purge VSV.