Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here


HINT:
Perform "Inspection After Repair" after replacing the air fuel ratio sensor (Click here).



1. INSTALL AIR FUEL RATIO SENSOR (for PZEV)


    A255136E01
  1. Using SST, install the air fuel ratio sensor to the exhaust manifold.
    Text in Illustration 
    *a
    Fulcrum Length
    30 mm
    *b
    Fulcrum Length
    300 mm

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    2. The "with SST" torque value is effective when SST is parallel to the torque wrench.

    HINT:
    Perform "Inspection After Repair" after replacing the air fuel ratio sensor (Click here).

  1. Connect the air fuel ratio sensor connector.



2. INSTALL AIR FUEL RATIO SENSOR (except PZEV)


    A254804E01
  1. Using SST, install the air fuel ratio sensor to the exhaust manifold.
    Text in Illustration 
    *a
    Fulcrum Length
    30 mm
    *b
    Fulcrum Length
    300 mm

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    2. The "with SST" torque value is effective when SST is parallel to the torque wrench.

    HINT:
    Perform "Inspection After Repair" after replacing the air fuel ratio sensor (Click here).

  1. Connect the air fuel ratio sensor connector.

  1. Install the hose clamp.



3. INSPECT FOR EXHAUST GAS LEAK


4. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR (except PZEV)
  1. Install the No. 1 exhaust manifold heat insulator with the 4 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }