Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR


    A255134E01
  1. Using SST, install the heated oxygen sensor to the front exhaust pipe.
    Text in Illustration 
    *a
    Fulcrum Length
    30 mm
    *b
    Fulcrum Length
    300 mm

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    NOTICE:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.) and a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here)
    2. The "with SST" torque value is effective when SST is parallel to the torque wrench.

  1. Connect the heated oxygen sensor connector.



2. INSPECT FOR EXHAUST GAS LEAK