DTC U0100 Lost Communication with ECM / PCM "A" |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0100 | Following conditions are met for 1.25 seconds (1 trip detection logic):
|
|
| Related DTCs | U0100: Verify communication |
| Required Sensors/Components (Main) | TCM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 1.25 seconds |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | None |
| Battery Voltage | 10.5 V or more |
| Engine switch | on (IG) |
| Starter | OFF |
| Communication between TCM and ECM | No communication |

| 1.CHECK ECU TERMINAL VOLTAGE (+B AND E1 TERMINALS) |
![]() |
Disconnect the TCM connector.
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E7-18 (+B) - E7-8 (E1) | Engine switch on (IG) | 9 to 14 V |
Turn the engine switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-8 (E1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to TCM) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TCM - ECM) |
Disconnect the TCM connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-6 (CAN+) - E26-31 (CAN+) | Always | Below 1 Ω |
| E7-7 (CAN-) - E26-1 (CAN-) | Always | Below 1 Ω |
| E7-6 (CAN+) or E26-31 (CAN+) - Body ground and other terminals | Always | 10 kΩ or higher |
| E7-7 (CAN-) or E26-1 (CAN-) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK IF DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Clear the DTCs.
Replace the TCM.
Start the engine.
Read the DTCs.
| Display (DTC Output) | Proceed to |
| U0100 | A |
| No DTC | B |
|
| ||||
| A | ||
| ||