STEERING GEAR > INSPECTION |
| 1. INSPECT TIE ROD ASSEMBLY |
![]() |
Secure the tie rod assembly in a vise.
Install the nut to the stud bolt.
Flip the ball joint back and forth 5 times.
Set a torque wrench to the nut, turn the ball joint continuously at a rate of 3 to 5 seconds per turn, and check the turning torque on the 5th turn.
| 2. INSPECT TOTAL PRELOAD |
![]() |
Install SST to the pinion shaft and turn it left and right 5 times or more.
Set a torque wrench to SST and turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.
| Grade | Specified Value |
| w/o Wireless Door Lock System | 0.7 to 1.1 N*m (7 to 11 kgf*cm, 6 to 9 in.*lbf) |
| w/ Wireless Door Lock System | 0.8 to 1.2 N*m (8 to 12 kgf*cm, 7 to 10 in.*lbf) |