STEERING LOCK SYSTEM > TERMINALS OF ECU |
| TERMINAL INSPECTION |

| *a | Component without harness connected (Steering Lock ECU (Steering Lock Actuator Assembly)) | - | - |
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Input/Output | Wiring Color | Terminal Description | Condition | Specified Condition | Related Data List Item |
| I24-1 (GND) - Body ground | - | W-B - Body ground | Ground* | Always | Below 1 Ω | - |
| I24-3 (IGE) - I24-1 (GND) | Input | SB - W-B | Steering lock motor activation command signal (motor activation command signal sent from certification ECU (smart key ECU assembly)) | Any door opened when conditions below met, and then steering lock motor activated:
| Pulse generation (see waveform) | Smart Key
|
| I24-4 (SLP1) - I24-1 (GND) | Output | P - W-B | Steering lock bar position signal (output signal from steering unlock sensor) | Steering locked → unlocked | 11 to 14 V → Below 1.2 V | Smart Key
|
| I24-5 (LIN) - I24-1 (GND) | Input/Output | V - W-B | LIN communication line | - | - | Smart Key
|
| I24-6 (IG2) - I24-1 (GND) | Input | LG - W-B | Power source mode signal (IG2 power supply input for entire steering lock actuator assembly)* | Engine switch off → engine switch on (IG) | Below 1 V → 11 to 14 V | Smart Key
|
| I24-7 (B) - Body ground | Input | B - Body ground | Power source* | Always | 11 to 14 V | - |
![]() |
Waveform
| Item | Content |
| Tester Connection | I24-3 (IGE) - I24-1 (GND) |
| Tool Setting | 2 V/DIV., 200 ms./DIV. |
| Vehicle Condition | Steering lock motor not operating → Steering lock motor operating → Steering lock motor not operating |
| *a | Steering lock motor not operating |
| *b | Steering lock motor operating |