NAVIGATION SYSTEM (for Radio and Display Type) > Data Signal Circuit between Stereo Jack Adapter and Extension Module |

| 1.CHECK HARNESS AND CONNECTOR (EXTENSION MODULE - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the extension module connector.
Disconnect the No. 1 stereo jack adapter assembly connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I146-2 (UDO-) - I175-2 (UDO-) | Always | Below 1 Ω |
| I146-3 (UDO+) - I175-3 (UDO+) | Always | Below 1 Ω |
| I146-5 (UJSS) - I175-5 (USG1) | Always | Below 1 Ω |
| I146-2 (UDO-) - Body ground | Always | 10 kΩ or higher |
| I146-3 (UDO+) - Body ground | Always | 10 kΩ or higher |
| I146-5 (UJSS) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Extension Module) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||