Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY

REAR LIGHT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR LIGHT ASSEMBLY LH


    E220265E03
  1. Disconnect the connector from the rear light assembly LH.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T18-2 (B/U) - T18-1 (E)
    Engine started and the shift lever not in R
    Below 1 V
    Engine started and the shift lever in R
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rear Light Assembly LH)
    If the result is not as specified, repair or replace the wire harness or connector.



2. INSPECT REAR LIGHT ASSEMBLY RH


    E220265E04
  1. Disconnect the connector from the rear light assembly RH.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T17-2 (B/U) - T17-1 (E)
    Engine started and the shift lever not in R
    Below 1 V
    Engine started and the shift lever in R
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Rear Light Assembly RH)
    If the result is not as specified, repair or replace the wire harness or connector.