AUDIO AND VISUAL SYSTEM (for Radio and Display Type without Intuitive Parking Assist System) > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the radio and display receiver assembly connector.
Disconnect the stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I69-5 (R+) - I134-8 (R+) | Always | Below 1 Ω |
| I69-4 (R-) - I134-18 (R-) | Always | Below 1 Ω |
| I69-3 (L+) - I134-9 (L+) | Always | Below 1 Ω |
| I69-2 (L-) - I134-19 (L-) | Always | Below 1 Ω |
| I69-6 (SLD) - Body ground | Always | 10 kΩ or higher |
| I69-5 (R+) - Body ground | Always | 10 kΩ or higher |
| I69-4 (R-) - Body ground | Always | 10 kΩ or higher |
| I69-3 (L+) - Body ground | Always | 10 kΩ or higher |
| I69-2 (L-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||