REAR CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL ENGINE REAR OIL SEAL |
![]() |
Apply MP grease to a new engine rear oil seal lip.
| *1 | Retainer |
| *a | Oil seal tap in depth (-0.5 to 0.5 mm) |
Using SST and a hammer, tap in the engine rear oil seal.
| 2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
Using SST, hold the crankshaft pulley.
Clean the 8 bolts and 8 bolt holes.
![]() |
Install the front drive plate spacer.
![]() |
Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.
| *1 | Drive Plate |
| *2 | Rear Spacer |
![]() | Transaxle Side |
![]() |
Apply adhesive to 2 or 3 threads of each bolt.
| *1 | Adhesive |
![]() |
In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
| 3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY |