FRONT CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL TIMING CHAIN COVER OIL SEAL |
Apply MP grease to the lip of a new oil seal.
![]() |
Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
| 2. INSTALL CRANKSHAFT PULLEY |
Align the pulley set key with the key groove of the crankshaft pulley.
![]() |
Using SST, hold the crankshaft pulley and install the pulley bolt.
| *a | Hold |
| *b | Turn |
| 3. INSTALL V-RIBBED BELT |
![]() |
Set the V-ribbed belt onto each part as shown in the illustration except the water pump pulley.
| *1 | Crankshaft |
| *2 | Tensioner |
| *3 | Generator |
| *4 | Water Pump |
| *5 | Cooler Compressor |
Loosen the V-ribbed belt by turning the belt tensioner clockwise.
Set the V-ribbed belt onto the water pump pulley.
| 4. INSTALL FRONT FENDER APRON SEAL RH |
| 5. INSTALL ENGINE UNDER COVER RH |
| 6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH |
| 7. INSTALL FRONT WHEEL RH |