Home › Engine / Hybrid System ยท 2GR-FE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL RH


2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH


3. REMOVE ENGINE UNDER COVER RH


4. REMOVE FRONT FENDER APRON SEAL RH


5. REMOVE V-RIBBED BELT


    A205850
  1. Release the V-ribbed belt tension by turning the V-ribbed belt tensioner counterclockwise, and remove the V-ribbed belt from the V-ribbed belt tensioner.

  1. While turning the V-ribbed belt tensioner counterclockwise, align its holes, and then insert a 5 mm hexagon wrench into the holes to fix the V-ribbed belt tensioner.



6. REMOVE CRANKSHAFT PULLEY


    A208600E03
  1. Using SST, loosen the crankshaft pulley bolt.

    SST
    09213-70011   (09213-70020)
    09330-00021  
    Text in Illustration 
    *a
    Hold
    V100135
    Turn



    A259943E01
  1. Using SST, remove the crankshaft pulley bolt and crankshaft pulley.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)
    Text in Illustration 
    *a
    Hold
    V100135
    Turn



    A205852
  1. Remove the pulley set key from the crankshaft.



7. REMOVE TIMING CHAIN CASE OIL SEAL


    A141580E04
  1. Using a knife, cut off the timing chain case oil seal lip.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Cut Position

  1. Using a screwdriver, pry out the timing chain case oil seal.

    NOTICE:
    After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

    HINT:
    Tape the screwdriver tip before use.