AUTOMATIC TRANSAXLE SYSTEM > ECU Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND) |
![]() |
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-8 (E1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to TCM) |
|
| ||||
| OK | |
| 2.INSPECT ECU TERMINAL VOLTAGE (+B TERMINAL) |
![]() |
Disconnect the TCM connector.
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E7-18 (+B) - Body ground | Engine switch on (IG) | 11 to 14 V |
| *a | Front view of wire harness connector (to TCM) |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (TCM - INTEGRATION RELAY) |
Remove the integration relay from the engine room relay block and junction block assembly.
Disconnect the integration relay connector.
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-18 (+B) - 1A-4 (+B) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| E7-18 (+B) or 1A-4 (+B) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||