Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > TERMINALS OF ECU

for Preparation Click here



AIR CONDITIONING AMPLIFIER ASSEMBLY

E226604E10

HINT:
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.


Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
I77-1 (IG+) - I77-14 (GND)
B - W-B
Power source (IG)
Ignition switch ON
11 to 14 V
I77-1 (IG+) - I77-14 (GND)
B - W-B
Power source (IG)
Ignition switch off
Below 1 V
I77-2 (SOL+) - I77-14 (GND)
W - W-B
Compressor solenoid operation signal
Engine running
A/C switch: on
Blower switch: LO
Pulse generation
(See waveform 1)
I77-5 (TAM) - I77-13 (SG-2)
P - GR
Ambient temperature sensor signal
Ignition switch ON
Ambient temperature: 25°C (77°F)
1.35 to 1.75 V
I77-5 (TAM) - I77-13 (SG-2)
P - GR
Ambient temperature sensor signal
Ignition switch ON
Ambient temperature: 40°C (104°F)
0.9 to 1.2 V
I77-7 (FLOQ) - I77-13 (SG-2)
G - GR
A/C flow sensor signal
Ignition switch ON
A/C switch: off
3.8 to 4.2 V
I77-7 (FLOQ) - I77-13 (SG-2)
G - GR
A/C flow sensor signal
Ignition switch ON
A/C switch: on
Blower switch: HI
0.7 to 3.8 V
I77-8 (LOCK) - I77-14 (GND)*1
SB - W-B
A/C lock sensor signal
Engine running
Blower switch: LO
A/C switch: on
Pulse generation
(See waveform 2)
I77-9 (PRE) - I77-13 (SG-2)
R - GR
Air conditioning pressure sensor signal
Engine running
A/C system operating
Refrigerant pressure: Abnormal pressure (more than 3025 kPa (30.9 kgf/cm2, 439 psi))
4.80 V or higher
I77-9 (PRE) - I77-13 (SG-2)
R - GR
Air conditioning pressure sensor signal
Engine running
A/C system operating
Refrigerant pressure: Abnormal pressure (less than 176 kPa (1.8 kgf/cm2, 25 psi))
Below 0.50 V
I77-9 (PRE) - I77-13 (SG-2)
R - GR
Air conditioning pressure sensor signal
Engine running
A/C system operating
Refrigerant pressure: Normal pressure (less than 3025 kPa (30.9 kgf/cm2, 439 psi) and more than 176 kPa (1.8 kgf/cm2, 25 psi))
0.50 to 4.80 V
I77-10 (S5-3) - I77-13 (SG-2)
V - GR
Power supply for air conditioning pressure sensor
Ignition switch ON
A/C switch: on
4.75 to 5.25 V
I77-10 (S5-3) - I77-13 (SG-2)
V - GR
Power supply for air conditioning pressure sensor
Ignition switch ON
A/C switch: off
Below 1 V
I77-11 (CANH) - I77-12 (CANL)
V - W
CAN communication system
CAN communication occurring
Pulse generation
I77-13 (SG-2) - Body ground
GR - Body ground
Ground for air conditioning pressure sensor, ambient temperature sensor, A/C lock sensor
Always
Below 1 V
I77-14 (GND) - Body ground
W-B - Body ground
Ground for main power supply
Always
Below 1 V
I77-20 (MGC) - I77-14 (GND)*1
B - W-B
Magnetic clutch operation signal
Engine running
Blower switch: LO
A/C switch: off
11 to 14 V
I77-20 (MGC) - I77-14 (GND)*1
B - W-B
Magnetic clutch operation signal
Engine running
Blower switch: LO
A/C switch: on
Below 1 V
I77-21 (B) - I77-14 (GND)
Y - W-B
Power source (Back-up)
Always
11 to 14 V
I77-22 (BLW) - I77-14 (GND)
R - W-B
Blower motor speed control signal
Ignition switch ON
Blower switch: LO
Pulse generation
(See waveform 3)
I77-29 (TR) - I77-34 (SG-1)
P - LG
Room temperature sensor signal
Ignition switch ON
Cabin temperature: 25°C (77°F)
1.8 to 2.2 V
I77-29 (TR) - I77-34 (SG-1)
P - LG
Room temperature sensor signal
Ignition switch ON
Cabin temperature: 40°C (104°F)
1.2 to 1.6 V
I77-30 (S5-1) - I77-13 (SG-2)
B - GR
Power supply for A/C flow sensor
Ignition switch off
Below 1 V
I77-30 (S5-1) - I77-13 (SG-2)
B - GR
Power supply for A/C flow sensor
Ignition switch ON
4.5 to 5.5 V
I77-32 (TSP) - I77-14 (GND)
Y - W-B
Solar sensor signal (for Front passenger side)
Ignition switch ON
Solar sensor subjected to electric light
0.8 to 4.3 V
I77-32 (TSP) - I77-14 (GND)
Y - W-B
Solar sensor signal (for Front passenger side)
Ignition switch ON
Solar sensor covered with a cloth
Below 0.8 V
I77-33 (TSD) - I77-14 (GND)
R - W-B
Solar sensor signal (for Driver side)
Ignition switch ON
Solar sensor subjected to electric light
0.8 to 4.3 V
I77-33 (TSD) - I77-14 (GND)
R - W-B
Solar sensor signal (for Driver side)
Ignition switch ON
Solar sensor covered with a cloth
Below 0.8 V
I77-34 (SG-1) - Body ground
LG - Body ground
Ground for room temperature sensor
Always
Below 1 V
I77-37 (LIN1) - I77-14 (GND)
V - W-B
LIN communication signal
Ignition switch ON
Pulse generation
z1-2 (BUS G) - Body ground
-
Ground for BUS IC
Always
Below 1 V
z1-3 (BUS) - z1-2 (BUS G)
-
BUS IC control signal
Ignition switch ON
Pulse generation
z1-4 (B BUS) - z1-2 (BUS G)
-
Power supply for BUS IC
Always
11 to 14 V
z1-5 (SGA) - Body ground
-
Ground for evaporator temperature sensor
Always
Below 1 V
z1-6 (TEA) - z1-5 (SGA)
-
Evaporator temperature sensor signal
Ignition switch ON
Evaporator temperature: 0°C (32°F)
1.7 to 2.1 V
z1-6 (TEA) - z1-5 (SGA)
-
Evaporator temperature sensor signal
Ignition switch ON
Evaporator temperature: 15°C (59°F)
0.9 to 1.3 V
  1. *1: for 2GR-FE


    E106664E02
  1. Waveform 1:
    Item
    Content
    Terminal No.
    I77-2 (SOL+) - I77-14 (GND)
    Tool Setting
    5 V/DIV., 500 μs/DIV.
    Vehicle Condition
    Engine running
    A/C switch: on
    Blower switch: LO



  2. E116941E01
  3. Waveform 2:
    Item
    Content
    Terminal No.
    I77-8 (LOCK) - I77-13 (SG-2)
    Tool Setting
    200 mV/DIV., 10 ms./DIV.
    Vehicle Condition
    Engine running
    Blower switch: LO
    A/C switch: on



  4. E103396E01
  5. Waveform 3:
    Item
    Content
    Terminal No.
    I77-22 (BLW) - I77-14 (GND)
    Tool Setting
    1 V/DIV., 500 μs/DIV.
    Vehicle Condition
    Ignition switch ON
    Blower switch: LO


AIR CONDITIONING CONTROL ASSEMBLY

E182384E05

HINT:
Check from the rear of the connector while it is connected to the air conditioning control assembly.


Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
I56-2 (IG+) - I56-6 (GND)
R - W-B
Power source (IG)
Ignition switch off
Below 1 V
I56-2 (IG+) - I56-6 (GND)
R - W-B
Power source (IG)
Ignition switch ON
11 to 14 V
I56-6 (GND) - Body ground
W-B - Body ground
Ground for air conditioning control assembly
Always
Below 1 V
I56-9 (LIN1) - Body ground
V - Body ground
LIN communication signal
Ignition switch ON
Pulse generation
I56-11 (ILL+) - Body ground
G - Body ground
Illumination signal
Light control switch off
Below 1 V
I56-11 (ILL+) - Body ground
G - Body ground
Illumination signal
Light control switch tail or head position
11 to 14 V
I56-15 (ILL-) - Body ground
SB - Body ground
Illumination signal
Light control switch off
Below 1 V
I56-15 (ILL-) - Body ground
SB - Body ground
Illumination signal
Light control switch tail or head position
Pulse generation