THEFT DETERRENT SYSTEM > SYSTEM DESCRIPTION |
| OUTLINE OF THEFT DETERRENT SYSTEM |
| w/ Daytime Running Light Control and Smart Key System | w/ Daytime Running Light Control and w/o Smart Key System | w/o Daytime Running Light Control and w/ Smart Key System | |
| Entry lock operation | ○ | - | ○ |
| Wireless lock operation | ○ | ○ | ○ |
| Key-linked lock operation | ○ | ○ | - |
Disarmed state:
Arming preparation state:
Armed state:
Alarm sounding state:
| Alarm Method | Headlights*1 | Blinking |
| Taillights*1 | Blinking | |
| Hazard Warning Lights | Blinking | |
| Interior Light*1 | Illuminating | |
| Vehicle Horns | Sounding (approx. 0.4-second cycles) | |
| Security Horn | Sounding (approx. 0.4-second cycles) | |
| Alarm Time |
| |
| FUNCTION OF MAIN COMPONENTS |
| Component | Function |
| Security indicator light | Informs driver of theft deterrent system status. |
| Security horn | Sounds when attempted break-in or theft is detected. |
| Headlights*1 | Blink when attempted break-in or theft is detected. |
| Taillights*1 |
|
| Hazard warning lights | Blink when attempted break-in or theft is detected. |
| Interior light*1 | Comes on when attempted break-in or theft is detected. |
| Vehicle horns | Sound when attempted break-in or theft is detected. |
| Door courtesy light switch | Detects door status (open or closed). |
| Door unlock detection switch | Detects door status (locked or unlocked). |
| Engine hood courtesy switch | Detects engine hood status (open or closed). |
| Luggage compartment door courtesy light switch | Detects luggage compartment door status (open or closed). |
| Certification ECU (smart key ECU assembly)*2 |
|
| Main body ECU (multiplex network body ECU)*3 | Receives wireless door lock/unlock signal. |
| Glass breakage sensor microphone*4 | Detects impact or breakage of glass. |
| Glass breakage sensor ECU*4 | Sends a signal to the main body ECU (multiplex network body ECU) to sound the alarm when glass breakage sensor microphone detects impact or breakage of glass. |
| ACTIVE ARMING MODE |
Active arming mode:
This system operates as described in the diagram below when one of the items for each condition is met.

| Condition | Item |
| Condition [1] | In disarmed state 1, when the ignition switch is off, the system state is switched if the following condition is met:
|
| Condition [2] |
|
| Condition [3] |
|
| Condition [4] |
|
| Condition [5] |
|
| Condition [6] |
|
| Condition [7] |
|
| Condition [8] |
|
| Condition [9] |
|
| Condition [10] | In disarmed state 1, when the ignition switch is off or the remote control starter is in use, the system state is switched if the following condition is met:
|
| Condition [11] |
|
| Condition | Item |
| Condition [1] | In disarmed state 1, when the ignition switch is off, the system state is switched if the following condition is met:
|
| Condition [2] |
|
| Condition [3] |
|
| Condition [4] |
|
| Condition [5] |
|
| Condition [6] |
|
| Condition [7] |
|
| Condition [8] |
|
| Condition [9] |
|
| Condition [10] | In disarmed state 1, when the ignition switch is off, the system state is switched if the following condition is met:
|
| Condition [11] |
|
| Condition | Item |
| Condition [1] | In disarmed state 1, when the ignition switch is off, the system state is switched if the following condition is met when the key is not in the key cylinder:
|
| Condition [2] |
|
| Condition [3] |
|
| Condition [4] |
|
| Condition [5] |
|
| Condition [6] |
|
| Condition [7] |
|
| Condition [8] |
|
| Condition [9] |
|
| Condition [10] | In disarmed state 1, when the ignition switch is off, the system state is switched if the following condition is met when the key is not in the key cylinder:
|
| Condition [11] |
|
| FORCED DOOR LOCK CONTROL |
The forced door lock control prevents the vehicle from being tampered with. Immediately after a door is unlocked (armed starts), all doors are forced to lock by a forced door lock signal.
If the following conditions are met, the forced door lock control is operated.
| ALARM MEMORY FUNCTION (w/ Daytime Running Light Control) |
If the alarm is set off (tampering is detected) while the theft deterrent system is armed, it will be stored by the alarm memory function. Whenever the theft deterrent system is cancelled, the alarm memory function causes the taillights to light up for 2 seconds in order to inform you that the alarm has been set off.
Conditions that cause the taillights to light up for 2 seconds:
The theft deterrent system has entered the alarm sounding state (tampering has been detected) at least once.
| PANIC ALARM CONTROL |
The panic alarm control makes it possible to voluntarily set off the panic alarm by pressing the panic switch on the wireless transmitter.
Conditions that cause the panic alarm control to set off the panic alarm:
The panic switch on the wireless transmitter is pressed under the following conditions:
Conditions that cause the panic alarm control to shut off the alarm:
Any of the following conditions is met during panic alarm operation:
| GLASS BREAKAGE SENSOR (w/ Glass Breakage Sensor) |
The glass breakage sensor detects impacts to or breakage of the glass. If the sensor detects any impacts or breakage while the theft deterrent system is functioning, it will sound an alarm for 57 seconds.
The sensitivity of the glass breakage sensor can be adjusted by the volume switch in the glass breakage sensor ECU.
| SECURITY INDICATOR LIGHT OUTPUT |
According to the state of the theft deterrent system, the main body ECU (multiplex network body ECU) outputs a signal to turn the security indicator light on. However, some of the actual lighting conditions of the security indicator light are different from the output signals of the main body ECU (multiplex network body ECU).
| State of Theft Deterrent System | Security Indicator Light | |
| Output Signal from Main Body ECU (Multiplex Network Body ECU) | Actual Lighting Condition | |
| Disarmed state (1), (2) | OFF | OFF (Engine immobiliser system unset) BLINKING (Engine immobiliser system set) |
| Arming preparation state | ON | ON |
| Armed state | OFF | BLINKING |
| Alarm sounding state | ON | ON |
| Time | Security Indicator Light |
| 0.125 sec. | ON |
| 1.875 sec. | OFF |