Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for 2AR-FE with Wireless Door Lock)

POWER STEERING SYSTEM (for 2AR-FE with Wireless Door Lock) > TERMINALS OF ECU

for Preparation Click here



CHECK POWER STEERING ECU ASSEMBLY

C245077E01


Text in Illustration 
*a
Component without harness connected
(Power Steering ECU Assembly)
-
-
  1. Measure the voltage and resistance according to the value(s) in the table below.

    NOTICE:
    When the P/S warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU assembly terminals to become 0 V.


    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    j1-1 (IG) - Body ground
    R - Body ground
    IG power source
    Ignition switch ON
    9 to 16 V
    j1-6 (TS) - Test mode terminal
    O - Body ground
    Test mode signal
    Always
    9 to 16 V
    j1-7 (CANH) - j1-8 (CANL)
    Y - SB
    CAN communication line
    Ignition switch off
    54 to 69 Ω
    z16-1 (TRQ2) - Body ground
    Y - Body ground
    Torque sensor signal
    Engine running
    Steering wheel not being turned (without load)
    2.3 to 2.7 V
    Engine running
    Steering wheel being turned to right with vehicle stopped
    1.2 to 2.5 V
    Engine running
    Steering wheel being turned to left with vehicle stopped
    2.5 to 3.8 V
    z16-2 (TRQG) - Body ground
    B - Body ground
    Torque sensor ground
    Always
    Below 1 Ω
    z16-8 (TRQV) - Body ground
    R - Body ground
    Torque sensor voltage source
    Engine running
    4.5 to 5.5 V
    z16-9 (TRQ1) - Body ground
    W - Body ground
    Torque sensor signal
    Engine running
    Steering wheel not being turned (without load)
    2.3 to 2.7 V
    Engine running
    Steering wheel being turned to right with vehicle stopped
    2.5 to 3.8 V
    Engine running
    Steering wheel being turned to left with vehicle stopped
    1.2 to 2.5 V
    j2-1 (PIG) - Body ground
    R - Body ground
    Power source
    Always
    9 to 16 V
    j2-2 (PGND) - Body ground
    B - Body ground
    Power ground
    Always
    Below 1 Ω
    If the result is not as specified, the ECU may have a malfunction.