Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for 2GR-FE)

POWER STEERING SYSTEM (for 2GR-FE) > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA

NOTICE:
  1. It is difficult to show the specified values (judgment values) clearly because freeze frame data values change significantly due to differences in measurement conditions, surroundings, or vehicle conditions. For this reason, there may be a problem even when the values are within specifications.
  2. Turn the engine switch on (IG) and park the vehicle on level ground. Check the freeze frame data by using the Techstream.

  1. Turn the engine switch off.

  2. Connect the Techstream to the DLC3.

  3. Turn the engine switch on (IG).

  4. Turn the Techstream on.

  5. Check the freeze frame data on the Techstream.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Meter Vehicle Velocity
    Vehicle speed from meter/
    Min.: 0 km/h (0 mph)
    Max.: 300.0 km/h (186.4 mph)
    0 km/h (0 mph)
    Engine running and vehicle stopped
    No significant fluctuation
    Engine running and vehicle driven at a constant speed
    Engine Revolution
    Engine speed/
    Min.: 0 rpm
    Max.: 12800 rpm
    No significant fluctuation
    Engine running at a constant speed
    Motor Actual Current
    Amount of current to motor/
    Min.: -327.68 A
    Max.: 327.67 A
    The value rises
    Engine running and steering wheel being turned
    Command Value Current
    Demanded amount of current to motor/
    Min.: -327.68 A
    Max.: 327.67 A
    Value changes in proportion to steering effort
    - The value rises in left turn
    - The value descends in right turn
    Engine running and steering wheel being turned
    Steering Angle Velocity
    Steering angle speed/
    Min.: -32768 deg/s
    Max.: 32767 deg/s
    Value changes in proportion to steering speed
    - The value rises in left turn
    - The value descends in right turn
    Engine running and steering wheel being turned
    Thermistor Temperature
    ECU substrate temperature/
    Min.: -40°C (-40°F)
    Max.: 150°C (302°F)
    -40°C to 150°C (-40°F to 302°F)
    Engine running
    PIG Power Supply
    Power source voltage to active motor/
    Min.: 0 V
    Max.: 20.1531 V
    9 to 16 V
    Engine running and steering wheel being turned
    IG Power Supply
    ECU power source voltage/
    Min.: 0 V
    Max.: 20.1531 V
    9 to 16 V
    Engine switch on (IG)
    Steering Wheel Torque
    Steering wheel torque/
    Min.: -327.68 Nm
    Max.: 7.00 Nm
    Value changes in proportion to steering effort
    - The value rises when turning left
    - The value descends when turning right
    Engine running and steering wheel being turned
    Motor Rotation Angle
    Motor rotation angle/
    Min.: 0 deg
    Max.: 1441.770 deg
    During steering operation, motor rotation angle value changes from 0 to 360°
    Engine running and steering wheel being turned
    Motor Voltage
    Motor power supply voltage/
    Min.: 0 V
    Max.: 98.000 V
    9 to 16 V
    Engine running
    Motor Terminal Volt (U)
    Motor terminal voltage (A phase)/
    Min.: 0 V
    Max.: 98.000 V
    Value changes within 4 to 35 V range
    Engine running and steering wheel being turned
    Motor Terminal Volt (V)
    Motor terminal voltage (B phase)/
    Min.: 0 V
    Max.: 98.000 V
    Value changes within 4 to 35 V range
    Engine running and steering wheel being turned
    Motor Terminal Volt (W)
    Motor terminal voltage (C phase)/
    Min.: 0 V
    Max.: 98.000 V
    Value changes within 4 to 35 V range
    Engine running and steering wheel being turned
    Torque Sensor 1 Output
    Torque sensor voltage/
    Min.: 0 V
    Max.: 4.9725 V
    2.3 to 2.7 V
    Engine running and steering wheel not being turned (without load)
    2.5 to 4.7 V
    Engine running and steering wheel being turned to the right with vehicle stopped
    0.3 to 2.5 V
    Engine running and steering wheel being turned to the left with vehicle stopped
    Torque Sensor 2 Output
    Torque sensor voltage/
    Min.: 0 V
    Max.: 4.9725 V
    2.3 to 2.7 V
    Engine running and steering wheel not being turned (without load)
    0.3 to 2.5 V
    Engine running and steering wheel being turned to the right with vehicle stopped
    2.5 to 4.7 V
    Engine running and steering wheel being turned to the left with vehicle stopped
    Battery Voltage
    Battery voltage/
    Min.: 0 V
    Max.: 25.5 V
    9 to 16 V
    Engine switch on (IG)
    PS Assist Signal
    Power steering assist signal/
    ON or OFF
    OFF
    Engine switch on (IG)
    ON
    Engine running