Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT

BLOWER UNIT > REASSEMBLY

for Preparation Click here



1. INSTALL BLOWER MOTOR WITH FAN SUB-ASSEMBLY


    E226848
  1. Install the blower motor with fan sub-assembly with the 3 screws.



2. INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY


    E226842
  1. Install the No. 1 blower damper servo sub-assembly with the 3 screws.



3. INSTALL CLEAN AIR FILTER


    E236498
  1. Install the clean air filter as shown in the illustration.



4. INSTALL AIR FILTER COVER PLATE


    E226843
  1. Engage the 2 claws to install the air filter cover plate.



5. INSTALL AIR DUCT SUB-ASSEMBLY


    E226840
  1. Engage the 4 claws to install the air duct sub-assembly.



6. INSTALL DRAIN COOLER HOSE


    E234897E01
  1. Install the drain cooler hose as shown in the illustration.
    Text in Illustration 
    *1
    Hose Notch
    *2
    Blower Case Assembly Rib



7. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    C129881
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

    Compressor oil:
    ND-OIL 8 or equivalent



    E227205
  1. Install the No. 1 cooler evaporator sub-assembly to the blower assembly.



8. INSTALL NO. 1 COOLER THERMISTOR


    E151029E04
  1. Install the No. 1 cooler thermistor as shown in the illustration.
    Part
    Length
    A
    34.3 mm
    1.35 in.
    B
    20.9 mm
    0.82 in.
    C
    50 mm
    1.96 in.
    Text in Illustration 
    *a
    Fixed Part
    *b
    Sensor Part

    NOTICE:
    1. Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
    2. When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
    3. After inserting the thermistor, do not apply excessive force to the wire.
    4. Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".

  1. Engage the 2 clamps.



9. INSTALL COOLER EXPANSION VALVE


    E227206
  1. Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }