Home › Drivetrain ยท U760E AUTOMATIC TRANSMISSION / TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > INSPECTION

for Preparation Click here



1. INSPECT DIFFERENTIAL SIDE GEAR BACKLASH


    C083562
  1. Hold the differential case in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. Place a dial indicator on the tip of the side gear tooth at a right angle.

  1. Hold the pinion gear in the differential case and measure the backlash of the side gear.

    Standard backlash:
    0.05 to 0.2 mm (0.00197 to 0.00787 in.)

    Thrust Washer Thickness 
    Thickness [mm (in.)]
    1.00 (0.0394)
    1.10 (0.0433)
    1.20 (0.0472)
    1.30 (0.0512)
    If the backlash is greater than the standard range, select another side gear thrust washer.