DIFFERENTIAL CASE > DISASSEMBLY |
| 1. REMOVE FRONT DIFFERENTIAL RING GEAR |
![]() |
Put matchmarks on the front differential ring gear and differential case.
| *a | Matchmark |
![]() |
Remove the 12 bolts.
![]() |
Using a plastic hammer, tap on the front differential ring gear to remove it from the differential case.
| 2. REMOVE FRONT DIFFERENTIAL CASE FRONT TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case front tapered roller bearing from the differential case.
| *a | Turn |
| *b | Hold |
![]() |
Using SST, remove the front differential case front tapered roller bearing outer race and shim from the transaxle housing.
| 3. REMOVE FRONT DIFFERENTIAL CASE REAR TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front differential case rear tapered roller bearing from the differential case.
| *a | Turn |
| *b | Hold |
![]() |
Using SST, remove the front differential case rear tapered roller bearing outer race from the transaxle case.
| 4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN |
![]() |
Using a pin punch (3 mm) and hammer, remove the straight pin.
| 5. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT |
![]() |
Remove the front No. 1 differential pinion shaft from the differential case.
| 6. REMOVE DIFFERENTIAL SIDE GEAR |
![]() |
Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 differential side gears and 2 No. 1 front differential side gear thrust washers from the differential case.
| 7. REMOVE FRONT TRANSAXLE CASE OIL SEAL |
![]() |
Using SST, remove the front transaxle case oil seal from the transaxle housing.
| 8. REMOVE TRANSAXLE CASE OIL SEAL |
![]() |
Using SST, remove the transaxle case oil seal from the transaxle case.