Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW MASTER SWITCH

POWER WINDOW MASTER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL


    B277183
  1. Using a moulding remover, disengage the 2 clips, 5 claws and 4 guides as shown in the illustration.

  1. Disconnect each connector and remove the power window regulator master switch assembly with front door armrest base panel.



2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


    B279236
  1. Remove the 3 screws and power window regulator master switch assembly from the front upper armrest base panel.