CAN COMMUNICATION SYSTEM > SYSTEM DIAGRAM |
| OVERALL CAN BUS DIAGRAM |
Control system CAN is composed of 2 buses.

| *1 | V Bus | *2 | Sub Bus 2 |
| *3 | V Bus Terminating Resistor | *4 | Sub Bus 2 Terminating Resistor |
| *5 | Combination Meter Assembly (for V Bus) | *6 | Main Body ECU (Multiplex Network Body ECU) (for V Bus) |
| *7 | Airbag Sensor Assembly (for V Bus) | *8 | DLC3 (for V Bus) |
| *9 |
| *10 | Network Gateway ECU*5 (for V Bus and Sub Bus 2) |
| *11 | Steering Sensor (for V Bus) | *12 | Air Conditioning Amplifier Assembly (for V Bus) |
| *13 | Clearance Warning ECU Assembly*6 (for V Bus) | *14 | Brake Actuator Assembly (Skid Control ECU) (for V Bus) |
| *15 | Smart Key ECU Assembly (Certification ECU)*4 (for V Bus) | *16 |
|
| *17 | Yaw Rate Sensor*10 (for V Bus) | *18 | ECM (for V Bus) |
| *19 | Blind Spot Monitor Sensor LH*5 (for Sub Bus 2) | *20 | Blind Spot Monitor Sensor RH*5 (for Sub Bus 2) |
| *21 | CAN No. 5 J/C*5 (for Sub Bus 2) | - | - |
| V BUS |


| SUB BUS 2 (w/ Blind Spot Monitor System) |
