DTC P0657 Actuator Supply Voltage Circuit / Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0657 | Throttle actuator power supply error (1 trip detection logic). | ECM |
| Related DTCs | P0657: Electronic throttle actuator supply voltage circuit range check |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | Throttle actuator |
| Frequency of Operation | Once per driving cycle |
| Duration | - |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | None |
| Both of the following conditions are met | - |
| Engine switch | On (IG) to off |
| Electric throttle actuator power supply voltage | 7 V or higher |
| Electric throttle actuator power supply | On |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P0657) |
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Clear the DTCs (Click here).
Turn the Techstream off.
Turn the engine switch off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the engine switch on (IG).
Wait 10 seconds or more.
Turn the engine switch off.
Wait 15 seconds or more.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG) and turn the Techstream on.
Wait 5 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P0657 is output | B |
|
| ||||
| A | ||
| ||