SAFETY CONNECT SYSTEM > DCM POWER SOURCE CIRCUIT |

| 1.CHECK HARNESS AND CONNECTOR (DCM (TELEMATICS TRANSCEIVER) - BATTERY AND GROUND) |
![]() |
Disconnect the I135 DCM (Telematics Transceiver) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I135-4 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I135-1 (+B) - I135-4 (E) | Always | 11 to 14 V |
| I135-7 (IG2) - I135-4 (E) | Engine switch on (IG) | 11 to 14 V |
| I135-8 (ACC) - I135-4 (E) | Engine switch on (ACC) | 11 to 14 V |
| *a | Front view of wire harness connector (to DCM (Telematics Transceiver)) |
|
| ||||
| OK | ||
| ||