AUDIO AND VISUAL SYSTEM (for Radio and Display Type without Intuitive Parking Assist System) > Radio Receiver Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY, BODY GROUND) |
Disconnect the radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I152-7 (GND1) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| I134-20 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I152-4 (+B1) - I152-7 (GND1) | Always | 11 to 14 V |
| I152-3 (ACC1) - I152-7 (GND1) | Ignition switch ACC | 11 to 14 V |
| I155-1 (IG) - I152-7 (GND1) | Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| I134-1 (+B1) - I134-20 (GND1) | Always | 11 to 14 V |
| I134-11 (ACC1) - I134-20 (GND1) | Ignition switch ACC | 11 to 14 V |
| I155-1 (IG) - I134-20 (GND1) | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||