Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM


E236968E01


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - BATTERY, BODY GROUND)
  1. Disconnect the radio and display receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below .

    Standard Resistance:
    for 6 Speakers 
    Tester Connection
    Condition
    Specified Condition
    I152-7 (GND1) - Body ground
    Always
    Below 1 Ω
    for 10 Speakers 
    Tester Connection
    Condition
    Specified Condition
    I134-20 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for 6 Speakers 
    Tester Connection
    Condition
    Specified Condition
    I152-4 (+B1) - I152-7 (GND1)
    Always
    11 to 14 V
    I152-3 (ACC1) - I152-7 (GND1)
    Ignition switch ACC
    11 to 14 V
    I155-1 (IG) - I152-7 (GND1)
    Ignition switch ON
    11 to 14 V
    for 10 Speakers 
    Tester Connection
    Condition
    Specified Condition
    I134-1 (+B1) - I134-20 (GND1)
    Always
    11 to 14 V
    I134-11 (ACC1) - I134-20 (GND1)
    Ignition switch ACC
    11 to 14 V
    I155-1 (IG) - I134-20 (GND1)
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)