Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

NAVIGATION SYSTEM (for Navigation Receiver Type) > Navigation Receiver Assembly Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the navigation ECU sub-assembly.

WIRING DIAGRAM


E226165E23


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - BATTERY, BODY GROUND)
  1. Disconnect the navigation ECU sub-assembly connectors.

  1. Measure the resistance according to the value(s) in the table below .

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I64-7 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I64-4 (+B1) - I64-7 (GND1)
    Always
    11 to 14 V
    I64-3 (ACC1) - I64-7 (GND1)
    Ignition switch ACC
    11 to 14 V
    I67-1 (IG) - I64-7 (GND1)
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)