BRAKE ACTUATOR > ON-VEHICLE INSPECTION |
| 1. CONNECT TECHSTREAM |
Connect the Techstream to the DLC3.
Start the engine and run it at idle.
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
| 2. INSPECT ACTUATOR MOTOR OPERATION |
Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test / Motor Relay.
Turn the motor relay on, and check for actuator motor operation sounds.
Turn the motor relay off.
Fully depress the brake pedal and hold it for approximately 15 seconds. Check that the initial pedal depth is maintained for the entire 15 seconds.
Turn the motor relay on, check that the pedal does not pulsate.
Turn the motor relay off and release the brake pedal.
| 3. INSPECT RIGHT FRONT WHEEL OPERATION |
Enter the following menus: Chassis / ABS /VSC/TRAC / Active Test / ABS Solenoid.
Depress the brake pedal and hold it.
Turn the SFRH and SFRR solenoids on simultaneously, and check that the pedal cannot be depressed further.
Turn the SFRH and SFRR solenoids off simultaneously, and check that the pedal can be depressed.
With the pedal still depressed, turn the motor relay on and check that the pedal returns.
Turn the motor relay off and release the brake pedal.
| 4. INSPECT OTHER WHEEL OPERATION |
Using the same procedure, check the solenoids for the other wheels.