Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > REASSEMBLY

for Preparation Click here



1. INSTALL MASTER CYLINDER RESERVOIR GROMMET
  1. Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new master cylinder reservoir grommets.

  1. Install the 2 master cylinder reservoir grommets to the brake master cylinder reservoir sub-assembly.



2. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Install the brake master cylinder reservoir sub-assembly to the brake master cylinder assembly.



3. INSTALL BRAKE MASTER CYLINDER STRAIGHT PIN
  1. Mount the brake master cylinder assembly in a vise.

    NOTICE:
    1. Place aluminum plates on the vise to prevent damage to the brake master cylinder assembly.
    2. Do not drop the brake master cylinder reservoir sub-assembly.



    C239197
  1. Using a pin punch and a hammer, tap in the brake master cylinder straight pin to secure the brake master cylinder reservoir sub-assembly.



4. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER


5. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY