Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR

WASHER MOTOR > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
  1. Remove the washer jar.

  1. Disconnect the windshield washer motor and pump connector.

    HINT:
    The check should be performed with the windshield washer motor and pump installed on the washer jar.

  1. Fill the washer jar with washer fluid.



    E132855E05
  1. Connect a battery positive (+) lead to terminal A54-1 of the windshield washer motor and pump, and a negative (-) lead to terminal A54-2.

  1. Check that washer fluid flows from the washer jar.

    OK:
    Washer fluid flows from the washer jar.

    Text in Illustration 
    *a
    Component without harness connected
    (Windshield Washer Motor and Pump Assembly)
    If the result is not as specified, replace the windshield washer motor and pump assembly.