BRAKE FLUID > REPLACEMENT |
| 1. FILL RESERVOIR WITH BRAKE FLUID |
![]() |
Remove the brake master cylinder reservoir filler cap.
Fill the reservoir with brake fluid.
| 2. BLEED BRAKE LINE |
Connect a vinyl tube to the bleeder plug.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1
When fluid stops coming out, tighten the bleeder plug and release the brake pedal.*2
Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out and a new brake fluid comes out.
Tighten the bleeder plug completely.
Repeat the above steps to replace the brake fluid of the brake lines for each wheel.
| 3. INSPECT FOR BRAKE FLUID LEAK |
| 4. INSPECT BRAKE FLUID LEVEL IN RESERVOIR |
![]() |
Check the fluid level.
| *a | MAX Line |
| *b | MIN Line |