DTC P060D Internal Control Module Accelerator Pedal Position Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060D | Either of the following conditions is met (1 trip detection logic):
| ECM |
| Related DTCs | P060D: Internal control module and accelerator pedal position performance |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 1 second |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | None |
| Difference of main accelerator pedal position and sub accelerator pedal position | 0.3 V or higher |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P060D) |
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Clear the DTCs (Click here).
Turn the Techstream off.
Turn the engine switch off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Wait for 16 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P060D is output | B |
|
| ||||
| A | ||
| ||