DTC P060B Internal Control Module A/D Processing Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060B | An ECM main CPU communication error (1 trip detection logic). |
|
| Related DTCs | P060B: Internal control module A/D processing performance |
| Required Sensors/Components (Main) | ECM |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 2 times: Case 2 10 times: Case 1 30 times: Case 3 and 4 |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | None |
| Both of the following conditions are met | - |
| Battery voltage | 8 V or higher |
| Starter | Off |
| Monitor runs whenever the following DTCs are not stored | None |
| Internal control module serial communication | Fail |
| AD converter | Fail |
| Knock control sensor circuit | Fail |
| Knock control sensor serial communication | Fail |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P060B) |
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Clear the DTCs (Click here).
Turn the Techstream off.
Turn the engine switch off.
Disconnect the Techstream.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Wait for 16 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P060B is output | B |
| DTC P060B and P0327, P0328, P0332 or P0333 are output | C |
|
| ||||
|
| ||||
| A | ||
| ||