Home › Engine / Hybrid System ยท 2GR-FE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ENGINE OIL LEVEL
  1. Warm up the engine, stop it and wait 5 minutes. The oil level should be between the engine oil level dipstick low level mark and full level mark.
    If the engine oil level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not add engine oil to above the full level mark.



2. INSPECT ENGINE OIL QUALITY
  1. Check the engine oil for deterioration, water contamination, discoloring or thinning.
    If the condition is visibly poor, replace the engine oil and engine oil filter.



3. INSPECT OIL PRESSURE
  1. Remove the oil pressure switch (Click here).



    A256238E01
  1. Install the oil pressure gauge with the adapter.
    Text in Illustration 
    *1
    Oil Pressure Gauge

  1. Warm up the engine.

  1. Check the oil pressure.

    Standard Oil Pressure:
    Engine Condition
    Oil Pressure
    Idle
    30 kPa (0.3 kgf/cm2, 4.4 psi) or more
    3000 rpm
    200 kPa (2.0 kgf/cm2, 29 psi) or more

    If the oil pressure is not as specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge with the adapter.

  1. Install the oil pressure switch (Click here).