Home › Engine / Hybrid System ยท 2AR-FE › FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)


2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A252641
  1. Disconnect the 3 harness clamps.

    NOTICE:
    Do not damage the wire harness.



    A252642
  1. Remove the harness protector from the wire harness.

    NOTICE:
    Do not damage the wire harness.



    A254931
  1. Disconnect the connector of the fuel sender gauge assembly.



    A254932E01
  1. Release the lock as shown in the illustration and slide the fuel sender gauge assembly to remove it.