SOLAR SENSOR > INSPECTION |
| 1. INSPECT SOLAR SENSOR (AUTOMATIC LIGHT CONTROL SENSOR) |
![]() |
Disconnect the solar sensor (automatic light control sensor) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I61-6 (CLTB) - I61-3 (CLTE) | Ignition switch off | Below 1 V |
| I61-6 (CLTB) - I61-3 (CLTE) | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Solar Sensor (Automatic Light Control Sensor)) |
![]() |
Reconnect the solar sensor (automatic light control sensor) connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I61-1 (TSL) - I61-3 (CLTE) | Sensor is exposed to electric light | 0.8 to 4.3 V |
| I61-1 (TSL) - I61-3 (CLTE) | Sensor is covered with a cloth | Below 0.8 V |
| I61-2 (TSR) - I61-3 (CLTE) | Sensor is exposed to electric light | 0.8 to 4.3 V |
| I61-2 (TSR) - I61-3 (CLTE) | Sensor is covered with a cloth | Below 0.8 V |
| *a | Component with harness connected (Solar Sensor (Automatic Light Control Sensor)) |