Home › Steering › STEERING COLUMN › STEERING WHEEL (for 4 Spoke)

STEERING WHEEL (for 4 Spoke) > REMOVAL

for Preparation Click here


NOTICE:
  1. Do not replace the spiral cable with the battery connected and the ignition switch ON.
  2. Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.
  3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.



1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


2. REMOVE HORN BUTTON ASSEMBLY
(Click here)


3. REMOVE STEERING WHEEL ASSEMBLY


    C239350E01
  1. Remove the steering wheel assembly set nut.
    Text in Illustration 
    *a
    Matchmark

  1. Put matchmarks on the steering wheel assembly and steering main shaft.

  1. Disconnect the connectors from the spiral cable sub-assembly.



    C239352E01
  1. Using SST, remove the steering wheel assembly.
    Text in Illustration 
    *a
    Turn
    *b
    Hold

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05070)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



4. REMOVE NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)


    C239372
  1. Remove the 2 screws.

  1. Disengage the claw and 2 pins to remove the No. 1 steering wheel ornament from the steering wheel sub-assembly.



5. REMOVE NO. 2 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)

HINT:
Use the same procedure for the No. 1 steering wheel ornament.



6. REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
  1. Disconnect the steering pad switch connector from the spiral cable sub-assembly.



    C239354
  1. Remove the 2 screws.

  1. Disengage the claw and 2 pins to remove the steering pad switch assembly (RH side) from the steering wheel sub-assembly.



    C239355
  1. Remove the 2 screws.

  1. Disengage the claw and 2 pins to remove the steering pad switch assembly (LH side) from the steering wheel sub-assembly.



7. REMOVE CRUISE CONTROL MAIN SWITCH


    E226401
  1. Remove the 2 screws.



    E226400
  1. Disconnect the connector and remove the cruise control main switch.



8. REMOVE CRUISE CONTROL SWITCH WIRE
  1. Remove the cruise control switch wire.



9. REMOVE STEERING SHAKE DAMPER


    C239357
  1. Remove the 2 screws and steering shake damper from the steering wheel sub-assembly.