VSC OFF SWITCH > INSPECTION |
| 1. INSPECT VSC OFF SWITCH |
![]() |
Make sure that there is no looseness in the locking part and the connecting part of the connector.
Disconnect the VSC OFF switch connector.
Check both the connector case and the terminal for deformation and corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 (+) - 3 (E) | Switch pushed in | Below 1 Ω |
| 6 (+) - 3 (E) | Switch not pushed in | 10 kΩ or higher |
| *a | Component without harness connected (VSC OFF Switch) |