Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
(Click here)


2. REMOVE FRONT BUMPER ASSEMBLY


    B279851E01
  1. Put protective tape around the front bumper assembly.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Use the same procedure for the RH side and LH side.



    B279838E01
  1. Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.
    Text in Illustration 
    *1
    Pin Hold Clip

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B279840
  1. Remove the 6 screws.



    B279841
  1. Disengage the 3 claws.

    HINT:
    Use the same procedure for the RH side and LH side.



    B279843E01
  1. Pull back the side of the front bumper assembly as shown in the illustration and disconnect each connector.
    Text in Illustration 
    *A
    w/ Intuitive Parking Assist System
    *B
    w/ Fog Light

    NOTICE:
    Do not apply excessive force when separating the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



    B279844
  1. Using a clip remover, remove the 3 clips.

  1. Remove the front bumper assembly.